RE: [nv-l] Node Status does not change
2005-07-08 07:30:28
Yes, NetView does not work if Terminal
Services are used in any way to connect to NetView.
Regards,
Michael Pearson
Tivoli NetView for UNIX and NT Support
Building 660, Office CC105B;
HWY. 54 & 600 PARK OFFICES DR
Research Triangle Park, N.C. 27709
(919) 254-2270
pearsom AT us.ibm DOT com
******************************************************************
******************************************************************
Need help with Tivoli Software Products?
Ask Tivoli!
http://www.tivoli.com/asktivoli
"praveen kumar"
<praveenkumar.nair AT ustri DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
07/07/2005 11:52 PM
|
To
| <nv-l AT lists.us.ibm DOT com>
|
cc
|
|
Subject
| RE: [nv-l] Node Status does
not change |
|
Hi all,
Are there any issues if we
connect through terminal service? And apply commands???
|
Praveen kumar
praveenkumar.nair AT ustri DOT com
|
721, Nila
Technopark, Trivandrum
Tel: ++91-471-2335777 extn 8652
Cell: ++91-934-914-0942
|
From: owner-nv-l AT lists.us.ibm DOT com
[mailto:owner-nv-l AT lists.us.ibm DOT com] On Behalf Of Mike Pearson
Sent: Thursday, July 07, 2005 9:34 PM
To: nv-l AT lists.us.ibm DOT com
Subject: Re: [nv-l] Node Status does not change
Just a wild question but are you using Terminal Services to access NetView
in any way?
Regards,
Michael Pearson
Tivoli NetView for UNIX and NT Support
Building 660, Office CC105B;
HWY. 54 & 600 PARK OFFICES DR
Research Triangle Park, N.C. 27709
(919) 254-2270
pearsom AT us.ibm DOT com
******************************************************************
******************************************************************
Need help with Tivoli Software Products?
Ask Tivoli!
http://www.tivoli.com/asktivoli
usman.taokeer AT s-iii DOT com
Sent by: owner-nv-l AT lists.us.ibm DOT com
07/07/2005 11:56 AM
|
To
| nv-l AT lists.us.ibm DOT com
|
cc
|
|
Subject
| [nv-l] Node Status does not
change |
|
Hi,
We are using Netview 7.1.4 FP3. My NetView Map shows all nodes as Yellow
(marginal). It was working fine but suddenly all the nodes staus changed.
Dont know what is wrong, i logged in to one router manually shut down and
and no shut an interface then its status changed in the MAP (back to green).
What is wrong, is it Switch Analyzer or some NetView Deamon.
What should i look for?
Regards,
Usman Taokere
Si3
|
|
|