Hi all,
Are there any issues if we connect through
terminal service? And apply commands???
|
Praveen kumar
praveenkumar.nair AT ustri DOT com
|
721, Nila
Technopark, Trivandrum
Tel: ++91-471-2335777 extn 8652
Cell: ++91-934-914-0942
|
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT com] On Behalf Of Mike Pearson
Sent: Thursday, July 07, 2005 9:34
PM
To: nv-l AT lists.us.ibm DOT com
Subject: Re: [nv-l] Node Status
does not change
Just a wild question but are you using Terminal
Services to access NetView in any way?
Regards,
Michael Pearson
Tivoli NetView
for UNIX and NT Support
Building 660, Office CC105B;
HWY. 54 & 600 PARK OFFICES DR
Research Triangle Park, N.C. 27709
(919) 254-2270
pearsom AT us.ibm DOT com
******************************************************************
******************************************************************
Need help with Tivoli Software Products?
Ask Tivoli!
http://www.tivoli.com/asktivoli
usman.taokeer AT s-iii DOT com
Sent
by: owner-nv-l AT lists.us.ibm DOT com
07/07/2005 11:56 AM
|
To
|
nv-l AT lists.us.ibm DOT com
|
cc
|
|
Subject
|
[nv-l] Node Status does not change
|
|
Hi,
We are using Netview 7.1.4 FP3. My NetView Map shows all nodes as Yellow
(marginal). It was working fine but suddenly all the nodes staus changed. Dont
know what is wrong, i logged in to one router manually shut down and and no
shut an interface then its status changed in the MAP (back to green). What is
wrong, is it Switch Analyzer or some NetView Deamon.
What should i look for?
Regards,
Usman Taokere
Si3