The Command MIB variables were supported by the old System Information
Agent (SIA) - my guess would be that you don't have that installed as it
was withdrawn many years ago. Does anyone know whether the SIA is still
around??
If you want to have your SNMP agent run commands for you, I would be
more tempted to look at using the Open Source net-snmp agent (also
described in that white paper) - you may well be able to make that do
what you want.
Cheers,
Jane
alejandro.gabay AT reuters DOT com wrote:
Hi al,l we are running Solaris 8, NV 7.14 FP2 together MLM. After configuring MLM
according to Jane's Cuyry white paper (which is indeed a vey helpful guide for installing
MLM into a solaris box ). we found that although "Threshold policies" work fine
the Command policy could not be distribute (it says setting MIB variable ..... to XXXX .
Reason :noSuchName).
Does anyone have a clue of what might be going wrong?.
B. Regards
Alejandro
-----------------------------------------------------------------
Visit our Internet site at http://www.reuters.com
Get closer to the financial markets with Reuters Messaging - for more
information and to register, visit http://www.reuters.com/messaging
Any views expressed in this message are those of the individual
sender, except where the sender specifically states them to be
the views of Reuters Ltd.
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2004 Jane Curry <jane.curry AT skills-1st.co DOT uk>. All rights
reserved.
|
