Re: [nv-l] Object Turn Red after Ping
2004-11-05 15:30:04
Mark,
I checked snmpwalk on interface as well as ip.. and they seem very fine.. This is a router basically going up and down..now may be as you said i need to check the snmp version on other end if it's faulty..
thanks,
Larry
Mark Sklenarik <marksk AT us.ibm DOT com> wrote:
Hi Larry, What you are describing sound like a something we have experienced with fault snmp agent, SNMPv3 agents or Red Hat 3.0 snmp agents. This may occur when NetView is configured to perform status checking using SNMP, but the snmp agent is not responding even thought you can ping the NIC. Also, check to make sure you can snmpwalk both the "ip" and "interface" MIB tables on the agent. NetView 7.1.3 FP3 works best went communicating with a SNMPv1 agent. In the case of Red Hat 3.0 we found that the agent (net-snmp) had a problem with indexing between the "interface" and "ip" index and address tables. We found that we had to update Red Hat 3.0 net-snmp c!
ode to
"net-snmp-5.0.9-2-30E.6" to resolve problem.
Mark F Sklenarik IBM SWG Tivoli Solutions Quality Assurance Business Impact Management and Event Correlation Software Quality Engineer IBM Corporation
| |
free lancer <larrytechie AT yahoo DOT com> Sent by: owner-nv-l AT lists.us.ibm DOT com
11/05/2004 02:12 PM
|
To
| nv-l AT lists.us.ibm DOT com
|
cc
|
|
Subject
| [nv-l] Object Turn Red after Ping |
|
Hi, We have Netview 7.1.3 FP3 on AIX 5.1. There is some strange behavior on some of the deivces on the Map. There are showing up as red on map. When i ping them, they come back up as green and status is up and right after some time they go red again. But there is no problem of events coming in from those devices. I'm cluless in here. Could some out there help me please. Many Thanks, Larry.
Do you Yahoo!? Check out the new Yahoo! Front Page. www.yahoo.com
Do you Yahoo!?
Check out the new Yahoo! Front Page. www.yahoo.com
|
|
|