It looks like the TEC adapter (tecad_nv6k) is doing the discarding. I
don't have all the classes loaded in the TEC rulebase, but I am looking
in the reception log using wtdumprl and I can't see anything there. I
have run the java-based utility from the Start Menu, but that does not
give me the option of selecting any traps other than those which were
loaded at the start of this installation. Got any idea how to tell that
tool that there are new traps? Or tell it I would like to be able to
forward ANY trap?
Thanks,
Brian
Brian W. Green
IBM Certified Deployment Professional
CGI Information Systems and Management Consulting
275 Slater Street, 14th Floor
Ottawa, Ontario
K1P 5H9
(613) 234-2155
brian.green AT cgi DOT com
-----Original Message-----
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT
com]
On Behalf Of Brian Kraftchick
Sent: Friday, October 01, 2004 2:25 PM
To: 'nv-l AT lists.us.ibm DOT com'
Subject: RE: [nv-l] Trap flow to TEC
Brian,
Is Netview discarding the event or is TEC discarding the event. I have
setup this exact scenario on the same platform as you. It my case, I
setup the new traps that I wanted to go to TEC as a new class, but
didn't define the class in a baroc file on the TEC server.
Also, if these are new traps, have you run the TEC_Config utility to
make sure that they are filtered "IN" ? Again, in our case I not only
had to define the traps in Netview as you have, but as a final step I
had to make sure that those specific traps were filtered "IN" so that
the TEC adapter would "pick them up" and forward them to TEC.
Brian
-----Original Message-----
From: Brian W Green [mailto:brian.green AT cgi DOT com]
Sent: Friday, October 01, 2004 1:48 PM
To: Netview Mailing List
Subject: [nv-l] Trap flow to TEC
I have a Netview server on NT, and I am trying to set up the flow of
traps to TEC. For the traps loaded during the install (there are about
115 of them) the flow works fine, but I am trying to load new traps and
get the flow working. I have edited the enterprise into the
tecad_nv6k.oid file, and edited the .cds and .conf files - but nothing
happens. Looking in the trace file (I edited tecad_nv6k.err) it is
matching, but it is discarding the event.
Does anyone know how to get this flowing correctly? I am running
Netview 7.1.4 on Windows 2000, and the TEC Server (3.9) is loaded on the
same server.
Thanks,
Brian
Brian W. Green
IBM Certified Deployment Professional
CGI Information Systems and Management Consulting
275 Slater Street, 14th Floor
Ottawa, Ontario
K1P 5H9
(613) 234-2155
brian.green AT cgi DOT com
|
