NetView is most concerned with these tables, at(ipNettoMedia), ip, interfaces
and system. Did you get all of those tables? Are they blocked by the SNMP
agent ACL configuration?

As a side note, there may be a few "no such name" errors. NetView may look
to see if the device is an MLM and/or a NetView server. If the machine in
question in not one of those two devices, you may get a "no such name" error.
Paul



On Monday 20 October 2003 08:02, Pal, Laszlo wrote:
> I did another test. When I run simple snmpwalk from the same machine to the
> same router I got back results, but when Netview tries to poll I still
> getting no such name erros.
>
> Do you have any idea? Community strings are correct in Netview
>
> Laszlo
>
> > -----Original Message-----
> > From: Pal, Laszlo [mailto:laszlo.pal AT eds DOT com]
> > Sent: Monday, October 20, 2003 10:06 AM
> > To: nv-l AT lists.us.ibm DOT com
> > Subject: RE: [nv-l] Nodes are Unknown
> >
> > The router managed by us but behind a firewall. IP/SNMP connectivity is
> > ok, but I cannot poll interfaces. I removed access list but it is still
> > tha same. It looks like some problem int he FW config
> >
> > Laszlo
> >
> > > -----Original Message-----
> > > From: Dietmar Gaulhofer [mailto:DIETMAR_GAULHOFER AT at.ibm DOT com]
> > > Sent: Friday, October 17, 2003 2:30 PM
> > > To: nv-l AT lists.us.ibm DOT com
> > > Subject: RE: [nv-l] Nodes are Unknown
> > >
> > >
> > > is this a router which is managed by a service provider ? had a problem
> > > once where they put a access-list on the router for snmp, and therefore
> > > the
> > > mib2 table was not complete. For the 0.0.0.0 is normaly a "unnumberd
> > > interface" - if you don't like that i think this can be turned off in
> >
> > ther
> >
> > > serversetup-netmon options, but in a "normal" installation they are
> > > usefull, because otherwise it will not connect to the remote routers
> >
> > with
> >
> > > a
> > > meta connection on the gui.
> > >
> > > no need to load any mibs for that....