The router managed by us but behind a firewall. IP/SNMP connectivity is ok, but 
I cannot poll interfaces. I removed access list but it is still tha same. It 
looks like some problem int he FW config

Laszlo


> -----Original Message-----
> From: Dietmar Gaulhofer [mailto:DIETMAR_GAULHOFER AT at.ibm DOT com]
> Sent: Friday, October 17, 2003 2:30 PM
> To: nv-l AT lists.us.ibm DOT com
> Subject: RE: [nv-l] Nodes are Unknown
> 
> 
> is this a router which is managed by a service provider ? had a problem
> once where they put a access-list on the router for snmp, and therefore
> the
> mib2 table was not complete. For the 0.0.0.0 is normaly a "unnumberd
> interface" - if you don't like that i think this can be turned off in ther
> serversetup-netmon options, but in a "normal" installation they are
> usefull, because otherwise it will not connect to the remote routers with
> a
> meta connection on the gui.
> 
> no need to load any mibs for that....
>