Re: [nv-l] Configuration of Event Threshold
2003-10-10 14:11:26
I haven't seen this before but there is an easy way around it. All NetView traps have the hostname of the monitored device as $2. I would always use that rather than $A.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group
| Peter.Ingleson AT gerlingncm DOT com
Sent by: owner-nv-l-digest AT lists.us.ibm DOT com
10/10/2003 09:52 AM
Please respond to nv-l
|
To: nv-l AT lists.us.ibm DOT com
cc:
Subject: [nv-l] Configuration of Event Threshold
|
List,
I have AIX5.1 with NV7.1.3,
I'm using threshold checking to monitoring errors on an array of cisco routers. This works correctly and re-arms the monitor when the condition meets, however I seem to be having a slight problem with trap customisation (IBM_NVDCOL_EV).
In the pop up notification I have the following
$A $3 $4 $+1 which works correctly, ie $A displays the hostname of the device with the errors, a router.
In command for automatic action I have the following
/home/$path/script.sh $A $3 $4 $+1
But the value in $A is the hostname of my Netview box and the not the monitored device.
Any thoughts would be appreciated.
Regards
Peter
------------------------------------------------------------------------------------------------------------
This message is intended for the addressee or its representative only.
Any form of unauthorized use, publication, reproduction, copying or
disclosure of the content of this e-mail is not permitted. If you are
not the intended recipient of this e-mail message and its contents,
please notify the sender immediately and delete this message and
all its attachments subsequently.
|
|
|