Re: [nv-l] NetView NT to Tec integration.

Don't assume that.

NetView for Windows and NetView for UNIX share less than 50 per cent of their code. They are two entirely separate products. While there are rulesets on Windows, they have nothing to do with sending events to TEC. The event flow is entirely different. The internal TEC adapter on UNIX is part of the nvserverd daemon, and he does not exist on Windows. That's why another daemon is needed and the development group which did NetView for Windows decided to port the tecad adapter shipped with TEC rather than invent their own.

James Shanks
Level 3 Support for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group

bill.kellam AT worldspan DOT com
Sent by: owner-nv-l-digest AT lists.us.ibm DOT com

10/03/2003 11:20 AM
Please respond to nv-l

To: nv-l AT lists.us.ibm DOT com
cc:
Subject: Re: [nv-l] NetView NT to Tec integration.

Edited the ruleset?
Restart trapd if it's a new enterprise.

I'm on Unix, but assume it's similar.

Bill Kellam
Enterprise Integration and Management

"John M Gatrell"
<John.Gatrell AT uk.ibm DOT co To: nv-l AT lists.us.ibm DOT com
m> cc:
Sent by: Subject: [nv-l] NetView NT to Tec integration.
owner-nv-l-digest@lists
.us.ibm.com

10/03/2003 11:04 AM
Please respond to nv-l

I'm running NV on windows 2000 SP4.
I'm receiving traps from an EMS unit.
Loaded the mib. Yes.
Run mib2trap. Yes
Run the batch file produced so that the addtraps update trapd.conf. Yes.
Handed over a baroc file to the Tivoli Tec administrator. Yes.

However only traps that were previously known are being forwarded
by the non-tmr tec adapter.

So how do I persuade the traps to go to the Tec?

John Gatrell, B.A. Physics, CCNA
RMSC - IBM UK's Remote Managed Services Centre
Tel: 0870-010-6284 Internal 814732