JT, you can use xnmloadmib2 to load v2 MIBs.

Fawad Qureshi
Division of Network Engineering

-----Original Message-----
From: Edwards, JT - ESM [mailto:JEdwards3 AT wm DOT com] 
Sent: Thursday, July 31, 2003 4:44 PM
To: Netview (E-mail)
Subject: [nv-l] Loading SNMP v2 MIBs 


Hello everyone,

I am trying to load a SNMP v2 MIB on a Netview 7.1.2 server. According to
the manual there is an option for v2 MIBs. However, on my Netview GUI there
is only an option for SNMP v1.

Am I missing something?

Thanks in advance,

J.T. Edwards
Sr. Systems Programmer
Enterprise Systems Management
Waste Management Incorporated
"Proud Sponsor of NASCAR"
Office: (713)265-1294
Mobile: (832)457-5239


---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group help line
at 1-800-TIVOLI8(848-6548)

---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)