Re: [nv-l] forwarding traps

Yes, but I am not certain that is the answer you are actually looking for.

traps are forwarded in the same way as they are received -- as hex data in SNMP PDU packets. MIBs, and their trap definitions, are only used to interpret incoming traps for display. Otherwise they are not necessary at all. So no trap definitions from MIBs are needed on either system for the forwarding to occur.

But how the traps display on the target system is another matter. They will be treated there as from any other source, just as they are on the originating system. If the trap definitions are not in trapd.conf, then you will see the "no fmt found" message accompany them when they are displayed or logged.

James Shanks
Level 3 Support for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group

"DePhillips, Frank" <fdephillips AT McLeodUSA DOT com>

07/01/2003 10:03 AM

To: nv-l AT lists.tivoli DOT com
cc:
Subject: [nv-l] fowarding traps

Since the MIBs are loaded on Netview if I forward traps to another system can it go to that system with out needing the MIBS to be loaded on that system also?

Thanks

Frank

NOTICE: This electronic mail transmission may contain confidential information and is intended only for the person(s) named. Any use, copying or disclosure by any other person is strictly prohibited. If you have received this transmission in error, please notify the sender via e-mail.