Dear all,
   My customer has a Layer-4 switch named Nortel Passport 8600, and insert
a WSM module on it. If I want to get the SNMP information about Passport
8600, I need to use community name A; if I want to get the SNMP information
about the WSM module, I need to use community name B, to the same IP
address. My problem is that in Netview I could set only one community name
for a specific IP, but in this case, there are two community names
correspond to two different devices on the same IP, in other words, I could
get SNMP information about one of them at the same time. My customer would
like to collect the MIB information of "both" ( use the data collection
function of Netview ), how should I do?  any hints may help, thanks........

Best Regards,
Fission Lin, 林倩全
I / T Specialist  , Tivoli Professional Services,
ITS/SMBU/NSM,  IBM Taiwan
206, Sec.1 Keelung Rd, Taipei, Taiwan, R.O.C.
Tel:886-2-2725-8872, Mobile:0935-558622
E-Mail: flin AT tw.ibm DOT com