This is a multipart message in MIME format. Try setting it in xnmsnmpconf. Both netmon and snmpCollect use that
information.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group
Jeff Law <jlaw AT ems-global DOT com>
Sent by: owner-nv-l AT tkg DOT com
11/07/2001 12:47 PM
Please respond to IBM NetView Discussion
To: nv-l AT tkg DOT com
cc:
Subject: [NV-L] Doing SNMP queries on ports other than 161
I have 1 device that I want to monitor/manage, that for security reasons I
suppose, is set up to use port 260 instead of 161.
Is there any way that I can configure this within NetView?
Regards
Jeff
______________________________________________________________
Jeff Law Email: jlaw AT ems-global DOT com
Technical Consultant Mobile: +64 21 664 595
DDI: +64 7 854 7369
EMS-Global Ltd Voice: +64 9 359 7003
P O Box 17 344 Fax: +64 9 300 6494
Auckland
NEW ZEALAND http://www.ems-global.com
______________________________________________________________
CONFIDENTIALITY NOTICE:
This message and any attachment(s) are confidential and proprietary. They
may also be privileged or otherwise protected from disclosure.
If you are not the intended recipient, advise the sender and delete this
message and any attachment from your system. If you are not the intended
recipient, you are not authorised to use or copy this message or
attachment or disclose the contents to any other person.
Views expressed are not necessarily endorsed by EMS-Global Limited.
Try setting it in xnmsnmpconf. Both netmon and snmpCollect use that information.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group
| Jeff Law <jlaw AT ems-global DOT com>
Sent by: owner-nv-l AT tkg DOT com
11/07/2001 12:47 PM
Please respond to IBM NetView Discussion
|
To: nv-l AT tkg DOT com
cc:
Subject: [NV-L] Doing SNMP queries on ports other than 161
|
I have 1 device that I want to monitor/manage, that for security reasons I suppose, is set up to use port 260 instead of 161.
Is there any way that I can configure this within NetView?
Regards
Jeff
______________________________________________________________
Jeff Law Email: jlaw AT ems-global DOT com
Technical Consultant Mobile: +64 21 664 595
DDI: +64 7 854 7369
EMS-Global Ltd Voice: +64 9 359 7003
P O Box 17 344 Fax: +64 9 300 6494
Auckland
NEW ZEALAND http://www.ems-global.com
______________________________________________________________
CONFIDENTIALITY NOTICE:
This message and any attachment(s) are confidential and proprietary. They may also be privileged or otherwise protected from disclosure.
If you are not the intended recipient, advise the sender and delete this message and any attachment from your system. If you are not the intended recipient, you are not authorised to use or copy this message or attachment or disclose the contents to any other person.
Views expressed are not necessarily endorsed by EMS-Global Limited.
|