This is a multipart message in MIME format. Hello Bernard,
Sorry, but no. At this time it is just subnetwork and location based.
Pam
Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
Sent by: owner-nv-l AT tkg DOT com
To: "'NETVIEW FORUM'" <nv-l AT tkg DOT com>
cc:
Subject: [NV-L] Disply scope in NetView 7.1
Hello,
the page 6 of the slides states that "Initially, Scoping is subnetwork
(and Location) based."
The example shown on the same slide is "69.0.254.5" which does not look
like a subnet but well like a host address.
Does this implies there is a possibility to restrict the display on a per
address basis ? That would be a very fine feature I would be interested
in a lot !
Thanks in advance for you answer.
Bernard Baudoux
Phone: +32 (0)2/565.24.68
e-mail : bernard.baudoux AT fortisbank DOT com
This email and any attached files are confidential and may be legally
privileged.
If you are not the intended recipient, any disclosure, reproduction,
copying, distribution, or other dissemination or use of this communication
is strictly prohibited.
If you have received this transmission in error please notify the sender
immediately and then delete this email.
Email transmission cannot be guaranteed to be secure or error free as
information could be intercepted, corrupted, lost, destroyed, arrive late
or
incomplete, or contain viruses.
The sender therefore is in no way liable for any errors or omissions in
the
content of this message, which may arise as a result of email
transmission.
If verification is required, please request a hard copy.
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
Hello Bernard,
Sorry, but no. At this time it is just subnetwork and location based.
Pam
Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
Sent by: owner-nv-l AT tkg DOT com
To: "'NETVIEW FORUM'" <nv-l AT tkg DOT com>
cc:
Subject: [NV-L] Disply scope in NetView 7.1
Hello,
the page 6 of the slides states that "Initially, Scoping is subnetwork (and Location) based."
The example shown on the same slide is "69.0.254.5" which does not look like a subnet but well like a host address.
Does this implies there is a possibility to restrict the display on a per address basis ? That would be a very fine feature I would be interested in a lot !
Thanks in advance for you answer.
Bernard Baudoux
Phone: +32 (0)2/565.24.68
e-mail : bernard.baudoux AT fortisbank DOT com
This email and any attached files are confidential and may be legally privileged.
If you are not the intended recipient, any disclosure, reproduction,
copying, distribution, or other dissemination or use of this communication
is strictly prohibited.
If you have received this transmission in error please notify the sender
immediately and then delete this email.
Email transmission cannot be guaranteed to be secure or error free as
information could be intercepted, corrupted, lost, destroyed, arrive late or
incomplete, or contain viruses.
The sender therefore is in no way liable for any errors or omissions in the
content of this message, which may arise as a result of email transmission.
If verification is required, please request a hard copy.
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|