I am sorry but I didn't see that the subject of your message said "Cisco Router
serial Link trap".  I presume the only way to stop this is to re-configure your
router, but I don't have a clue how to do it.

James Shanks
Tivoli (NetView for UNIX) L3 Support



James Shanks <James_Shanks AT TIVOLI DOT COM> on 10/18/99 09:27:41 AM

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.UCSB DOT EDU>

To:   NV-L AT UCSBVM.UCSB DOT EDU
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  Re: Cisco Router Serial Link Trap




Have you tried unmanaging the interface from the GUI?

James Shanks
Tivoli (NetView for UNIX) L3 Support



"Chance, Larry" <lchance AT SFBCIC DOT COM> on 10/18/99 09:01:09 AM

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.UCSB DOT EDU>

To:   NV-L AT UCSBVM.UCSB DOT EDU
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  Cisco Router Serial Link Trap




NetView for NT

I have a serial link that's going up and down 3 times a minute.
This will go on until the T1 vendor gets their act together and
can make the link stay up.

But in the meantime, Does anyone know how I can single out
this interface to stop sending traps?

tia