We ran into a similar problem with the CIP MIBs in our environment trying to
build collections.

The CIP MIBs are mostly SNMPv2 if I remember. I believe that "xnmcollect"
supports only SNMPv1, and I would bet that the MIB Tool Builder uses xnmcollect
under the covers.

HTH

Dean





"Chance, Larry" <lchance AT SFBCIC DOT COM> on 09/14/99 01:27:33 PM

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.ucsb DOT edu>

To:   NV-L AT UCSBVM.ucsb DOT edu
cc:    (bcc: Dean Grant/AIS/US/Ahold)
Subject:  CIP - Channel Interface Processor (in Cisco Router)



Anyone using a CIP in a mainframe environment?

I have one but I can't seem to access it with the MIB Tool Builder.
After creating 'MyCIP-MIBTool', any MIB data I try to read says <No Value>.
This is only when using Monitor, Other, MyCIP-MIBTool.

However, if I just use TOOLS, MIB, BROWSER, then I can get all the data
values I want.

I'm wondering, is there something special about setting SNMP on the CIP
physical interface?  Although the router is already set up with SNMP.
Would that be a different requirement for the MIB Tool Builder?

I'm puzzled why the MIB Browser works and the MIB Tool Builder doesn't.

Larry