Anyone using a CIP in a mainframe environment?
I have one but I can't seem to access it with the MIB Tool Builder.
After creating 'MyCIP-MIBTool', any MIB data I try to read says <No Value>.
This is only when using Monitor, Other, MyCIP-MIBTool.
However, if I just use TOOLS, MIB, BROWSER, then I can get all the data
values I want.
I'm wondering, is there something special about setting SNMP on the CIP
physical interface? Although the router is already set up with SNMP.
Would that be a different requirement for the MIB Tool Builder?
I'm puzzled why the MIB Browser works and the MIB Tool Builder doesn't.
Larry
|