Re: How can I get the agent address in a trap if it is not sent?

Subject:	Re: How can I get the agent address in a trap if it is not sent?
From:	James Shanks <James_Shanks AT TIVOLI DOT COM>
To:	nv-l AT lists.tivoli DOT com
Date:	Fri, 10 Sep 1999 13:00:49 -0400

The most concise information about formatting traps is in the man page for
trapd.conf.   Type "man trapd.conf" and you will see the $A and other trap
variables referenced there.  If you are unsure about what the man page says,
then yes, this is covered in the manuals, mostly the Admin Guide, under the long
chapter on Configuring events.

James Shanks
Tivoli (NetView for UNIX) L3 Support



Roberto Greco <roberto_greco AT IT.IBM DOT COM> on 09/10/99 12:26:52 PM

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.UCSB DOT EDU>

To:   NV-L AT UCSBVM.UCSB DOT EDU
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  Re: How can I get the agent address in a tarp if it si not sent?
      (was nothing)




Ok. I miss the information on $A.

   The only informations I get is on MIB descriptions.
   I suppose that I can found these new (for me) informations on TME 10 Netview
manuals.

Thank you very much