Frame Relay Monitoring

I have been trying to get the PVC data directly from the NT snmpcollect
database to graph elsewhere, but there is no dlci associated with
frCircuitSentOctets or frCircuitReceivedOctets, can anyone help?

>-----Original Message-----
>From:  Faltman [SMTP:Faltman]
>Sent:  Friday, June 05, 1998 12:58 AM
>To:    NV-L AT UCSBVM.UCSB DOT EDU
>Subject:       Re: Frame Relay Monitoring
>
>Also check out the standard MIB-II under
>transmission/frame-relay/frCircuitTable/frCircuitEntry/
>
>To check you dcli use frCircuitDlci, this i your MIB instances.
>And use for example frCircuitSentOctets and frCircuitReceivedOctets to
>monitor your Frame-Relay PVC bandwidth.
>
>--Mikael
>
>> -----Original Message-----
>> From: Owens, Blaine [SMTP:bowens AT EASTMAN DOT COM]
>> Sent: Wednesday, June 03, 1998 9:48 PM
>> To:   NV-L AT UCSBVM.UCSB DOT EDU
>> Subject:      Re: Frame Relay Monitoring
>>
>> Eddie, Cisco adds MIB instances (in FIFO sequence) for the
>> sub-interfaces, but I think you need to be at IOS 10.x (don't remember
>> the "x" off the top of my head). For example, if you have 20 physical
>> interfaces, the 1st subinterface will be instance 21, etc. Do a
>> snmpwalk
>> on ifDesc to clarify which instance numbers represent which
>> subinterfaces. WARNING - whenever the Cisco reboots it will renumber
>> the
>> instance numbers in a more logical sequence, so the numbers are
>> subject
>> to change on you. WARNING #2 - PRI interfaces speak with forked tongue
>> (they lie). Fortunately, the far end of our PRI circuits are regular
>> serial interfaces so I am able to gather stats from the far end. BRI
>> interfaces seem to report accurate data. Hope this helps.
>>
>> Blaine Owens
>> bowens AT eastman DOT com
>>
>> > -----Original Message-----
>> > From: Adair, Eddie [SMTP:eadair AT FRK DOT COM]
>> > Sent: Wednesday, June 03, 1998 3:22 PM
>> > To:   NV-L AT UCSBVM.ucsb DOT edu
>> > Subject:      Frame Relay Monitoring
>> >
>> > Hello,
>> >
>> > Could anyone tell me how to go about managing Frame Relay
>> > sub-interfaces
>> > for Cisco routers.  Netview (V4.1) discovers the interface, but I am
>> > unable to gather any statistics as I would on a normal Serial link.
>> > I'd
>> > like to be able to graph utilization on those sub-interfaces.
>> >
>> > I've tried loading the Cisco-Frame-Relay mib into Netview, but this
>> > doesn't seem to help.
>> >
>> > Any help would be appreciated.
>> >
>> > Regards,
>> >
>> > Eddie Adair