Hi Dennis

Try to create the volmgr logs under volmgr/debug and put verbose in vm.conf

Sometimes a manually start of ltid from the prompt can give an indication of 
the problem

My guess from what you write is that B and C is communicating properly with the 
robot

Regards
Michael

> Den 12/11/2013 kl. 02.48 skrev Dennis Peacock <nbu-forum AT backupcentral DOT 
> com>:
> 
> AIX 7.1 boxes.
> Node A - Master/Media server with fiber attached LTO-5 library.
> Node B - Media server/client with tape drives  in the Node-A library zoned so 
> Node B can see the drives.
> 
> Setup a regular flat file type backup for Node B and tell the policy to use 
> Node B as the media server. Kick off the backup and the job starts but sits 
> there "Mounting" for hours. I kill it...cycle Netbackup on both the 
> client/media server and the Master/Media. I check bp.conf file, I check 
> tpconfig, I check a bunch of stuff and no such luck.
> This is a new setup, master/media server works and runs perfectly. Node B and 
> Node C work perfectly as long as they are not set to use themselves as the 
> media server.
> 
> What am I missing?
> 
> +----------------------------------------------------------------------
> |This was sent by dpeaco AT acxiom DOT com via Backup Central.
> |Forward SPAM to abuse AT backupcentral DOT com.
> +----------------------------------------------------------------------
> 
> 
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu