[Veritas-bu] delay jobs from starting
2011-09-09 12:12:17
Problem: A job occasionally runs more than 24 hours pushing the backup
into the next day's start window. Once the original job finishes, it
appears to wait a minute and then starts again because it's within it's
new start window. Is there a setting or way to force the job to delay
starting until a certain amount of time has elapsed since it finished
last?
My challenge came up with a Exchange 2003 backup running into the next
day. The job finished, then the snapshot job finished. Exactly one
minute after the snapshot job finished, it tried to snap the Exchange
box again. The backups are now failing with a status 130 error, and the
Exchange VSS Writer shows "Retryable state." Our assumption is that VSS
wasn't done with the original backup, and Netbackup asked it to perform
another snapshot, causing it to go into a unstable state.
Thoughts or solutions?
Running Netbackup 7.1.0.1
Thanks!
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [Veritas-bu] delay jobs from starting,
. . <=
|
|
|