[Veritas-bu] Drive Type
2006-07-19 05:10:05
Subject: |
[Veritas-bu] Drive Type |
From: |
Asiye.Yigit at gantek.com (Asiye Yiğit) |
Date: |
Wed, 19 Jul 2006 12:10:05 +0300 |
Hi William,
Thank you so much for your explanation. It is very helpful.
Asiye
-----Original Message-----
From: william.d.brown at gsk.com [mailto:william.d.brown at gsk.com]
Sent: Wednesday, July 19, 2006 12:03 PM
To: Asiye.Yigit at gantek.com
Cc: veritas-bu at mailman.eng.auburn.edu;
veritas-bu-bounces at mailman.eng.auburn.edu
Subject: Re: [Veritas-bu] Drive Type
I'm fairly sure that the HCART vs HCART2 has no effect on density etc.
The
settings for this are controlled in a couple of places, but relate to
the
configuration of the drive at the OS level.
At the UNIX OS level there are several device files created, with
different characteristics - all compatible with the drive. There will
normally be a "no-rewind" set which have to be used for NetBackup, but
there will also often be ones with and without compression enabled.
You
see similar with a NetApp, it will offer a set of devices with
differrent
capacities for the same physical drive, so when you set up an NDMP drive
on a NetApp you pick the one that gets the most on the tape.
The st.conf is used to map the SCSI answerback string of the drive to a
set of configuration parameters. The answer string must be an exact
match to what the drive sends, but you may be able to play around with
the
configuration options that are matched to it. You can enable fixed
block size quite simply (but don't!), but there is a bitmask that is I
think sent to the drive that will affect how it behaves. I would be
fairly sure that this is where you would have to tinker if you wanted to
make say an LTO3 write at LTO2 density on an LTO3 tape - if it is even
capable of doing so. I think this is used for the SCSI 'Mode Select'
command. In general I would avoid touching these values.
>From what you say you don't actually *want* to do any of that!
Otherwise, as Simon and others have said, all that matters is the media
type and drive type as NetBackup knows them must match or it will not
load
the tape. For example although an LTO3 drive can read and write LTO2
tape
(and does it faster than an LTO2 drive), NetBackup has no way to set
backwards read/write compatibility rules. BackupExec does!
So if the only LTO you have is LTO3, feel free to call them HCART -
otherwise when LTO6 comes you will have to call them HCART2 or something
silly. It really is just a name.
William D L Brown
"Asiye Yi?it" <Asiye.Yigit at gantek.com>
Sent by: veritas-bu-bounces at mailman.eng.auburn.edu
18-Jul-2006 20:09
Please respond to Asiye.Yigit at gantek.com
To
veritas-bu at mailman.eng.auburn.edu
cc
Subject
[Veritas-bu] Drive Type
Hi All,
I have a question. Is the NetBackup adjusting density according to the
drive type? I mean if I set drive density to hcart2 for hcart3 drive,
what would the capacity for that media? Is it like hcart3 regardless of
the setting in netbackup?
Regards,
_______________________________________________
Veritas-bu maillist - Veritas-bu at mailman.eng.auburn.edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|