[Veritas-bu] problem adding new drive to our L180

2003-07-02 17:21:20
Subject: [Veritas-bu] problem adding new drive to our L180
From: Mark.Donaldson AT experianems DOT com (Donaldson, Mark)
Date: Wed, 2 Jul 2003 15:21:20 -0600
Depending on what target was added, you may have to modify the
/kernel/drv/st.conf file.  You might also try & see if the "sgscan tape"
command shows the drive.

If you shutdown to the bios, you might try:

setenv auto-boot? false

Make sure the new tape drive is visible with the probe-scsi-all.

...when done...
setenv auto-boot? true

-----Original Message-----
From: King, Cheryl [mailto:cheryl.king AT intrado DOT com]
Sent: Wednesday, July 02, 2003 2:57 PM
To: Veritas-Bu (E-mail)
Subject: [Veritas-bu] problem adding new drive to our L180

STK installed a new drive (the third) to our L180 connected to a SUN running
NetBackup 4.5.  I did the following but the Sun doesn't see the new drive.

touch /reconfigure
shutdown the SUN server and L180
installed the drive and verified that the robot had three drives
brought up the SUN server

Any ideas would be appreciated.  

                                Cheryl King
                                Systems Administrator II
                                Intrado Inc.
                                1601 Dry Creek Road
                                Longmont, CO  80503-6493
                                direct: 720.864.5162
                                fax: 720.494.6600
                                email: cheryl.king AT intrado DOT com

                                Intrado. Informed Response.TM

The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain confidential or privileged information. If you are not the intended
recipient, please notify Intrado Inc. immediately at (720) 494-5800 and
destroy all copies of this message and any attachments.

Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu

<Prev in Thread] Current Thread [Next in Thread>