Tape devices are not assigned to storage units directly, only robot numbers.
The tape devices are actively selected when the storage unit is used.  You
can only limit the number of tapes drives as compared to the drive count in
the robot (use 3 of 4 possible drives, for example).

You can get storage unit information from bpstulist.  You can get drive &
robot information from tpconfig.

HTH - Mark

-----Original Message-----
From: MOYES-CLARK,SHANNON (HP-FtCollins,ex1) [mailto:shannonm AT hp DOT com]
Sent: Monday, May 05, 2003 5:04 PM
To: 'veritas-bu AT mailman.eng.auburn DOT edu'
Subject: [Veritas-bu] Trying to list devices from the command line


Hi all,

        I am new to Net Backup and I am trying to build some customized
reports.  I need to be able to provide a list of the devices in each Storage
Unit using the command line (so I can automate it).  This needs to go all
the way into mapping individual drives that are standalone an also each
drive in a robotics library mapped into the robotics library and then into
the Storage Unit.  I have dug through the documentation and tried all of the
commands, and I can not find this functionality.  I must be missing
something and I am hoping that someone here can point me in the correct
direction.

Thanks,

Shannon

Shannon J. Moyes Clark
Software Engineer
Storage Software Division
Hewlett Packard Company
shannon.moyes-clark AT hp DOT com < <mailto:shannon.moyes-clark AT hp DOT com>>
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 
All of that legal stuff about the opinions expressed here being mine and not
those of HP.
 
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu