Paul,
In answer to question 3
In your /kernel/drv/st.conf, you need the following selected;
"QUANTUM DLT7000", "Quantum DLT7000", "DLT7k-data",
and
DLT7k-data = 1,0x38,0,0x1D639,4,0x82,0x83,0x84,0x85,2;
Regards,
Mark
Paul Windsor wrote:
> We are using NetBackup 3.2 on a SUN4000 (Solaris 2.6) and using two STK
> 9710 silos with 10 DLT 4000 each. Our plan is to upgrade the tape drives
> to DLT 7000s. The questions are:
>
> 1. Will NetBackup be able to read existing backup tapes ( the DLT IV
> carts are used )
>
> 2. After the upgrade will the tapes be written in DLT7000 mode or
> must the tapes be blank labeled
>
> 3. I have seen several different DLT7000 definitions for the st.conf
> file .... what is correct
>
> Thanks for the help,
>
> Paul
> _______________________________________________
> Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|