Re: [Bacula-users] [9.0.0] Disabled Jobs don't show in log, "run"-Comman

Subject:	Re: [Bacula-users] [9.0.0] Disabled Jobs don't show in log, "run"-Command nor in Job table
From:	Kern Sibbald <kern AT sibbald DOT com>
To:	Uwe Schuerkamp <uwe.schuerkamp AT nionex DOT net>, Bacula Users Mailing List <bacula-users AT lists.sourceforge DOT net>
Date:	Thu, 20 Jul 2017 17:39:56 +0200

This is a feature that was requested by users.

Jobs that are disabled are no longer listed in the list of jobsavailable to be run. If you manually run a disabled job, it will stillrun.


Best regards,

Kern


On 07/20/2017 03:40 PM, Uwe Schuerkamp wrote:

Hi folks,

I have a few jobs that I run manually from time to time and so I've
set them to "Enabled = False" in their job definition.

It seems that as of 9.0.0, running these jobs no longer shows up in
bacula's log nor in the Job table. Also, they're not listed in the job
list anymore when I simply type "run", however when I type

run job="<disabled job name>"

they're still recognized.

Everything worked fine in 7.4.4, is this a bug or a feature?

All the best & TIA,

Uwe



------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users

Re: [Bacula-users] [9.0.0] Disabled Jobs don't show in log, "run"-Command nor in Job table