Re: [Bacula-users] Bacula 7.2 tape error from powerfail
2016-02-14 16:34:08
Set the tape status to recycle and re-write over it from the beginning.
On 02/14/2016 11:26 AM, philhu wrote:
> I have an lt04 tape system. All jobs write to the tapes in one pool. A
> specific tapw was in the drive, half full or so from oler backup jobs
>
> During a tape job today, we had a power fail due to flickering power. Nothing
> went off completely, but tape stopped writing and bacula timed out and
> marked job cancelled and marked tape status 'error'
>
> So I reset all, system runs fine on other tapes. So I mark tape in error back
> to append
>
> Trying to use it, bacula seeks to end of old data, hits eot and dies with i/o
> error
>
> Is there and way to start using the tape again? The command 'list volumes'
> shows how much tape is actually used. I think i need to write eofs at the end
> of the old data. How do i seek to end of old data and weof at end. Or should
> i just mark tape full to save the old savesets on it?
>
> +----------------------------------------------------------------------
> |This was sent by phil AT isone DOT biz via Backup Central.
> |Forward SPAM to abuse AT backupcentral DOT com.
> +----------------------------------------------------------------------
>
>
>
> ------------------------------------------------------------------------------
> Site24x7 APM Insight: Get Deep Visibility into Application Performance
> APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month
> Monitor end-to-end web transactions and take corrective actions now
> Troubleshoot faster and improve end-user experience. Signup Now!
> http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140
> _______________________________________________
> Bacula-users mailing list
> Bacula-users AT lists.sourceforge DOT net
> https://lists.sourceforge.net/lists/listinfo/bacula-users
>
------------------------------------------------------------------------------
Site24x7 APM Insight: Get Deep Visibility into Application Performance
APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month
Monitor end-to-end web transactions and take corrective actions now
Troubleshoot faster and improve end-user experience. Signup Now!
http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|