> > Hello,
> > is there a way to get concurrent backup jobs running on a single storage
> > Device?

> Sure. Just define the jobs, schedule them, and make sure the "Maximum
> Concurrent Jobs" setting is set where it's needed.

Already did that following the bacula documentation on concurrent jobs
but didn't work, still all jobs run in series. Until now I thought this
was related to me using only a single Storage Device (Device section in
bacula-sd.conf)

> > From what i read concurrent jobs have to be stored to different devices

> No.

> > due to the "tape-focused" architecture of bacula, but I'm storing all
> > backups on a Raid10 array with "Maximum Volume Jobs = 1" and this could
> > handle several concurrent writes no problem.
> >
> > And if this doesn't work I could simply set up a couple folders on my
> > Raid and declare a single Device for each folder to get some
> > concurrency, right?

> Right.
>
> But I guess you're confusing volumes and storage devices.
>
> Unless, of course, you want the concurrent jobs stored in different pools.

Yes, I have my Pools set up for different Volume Retention Times so the
Jobs I want to run concurrently will most likely use different Pools on
the Same Storage (Storage Section in bacula-dir.conf) I didn't think
this would be a problem though..

> Arno

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users