[Bacula-users] Question about 2.4.0 and manual tape changes

I have an autochanger and its been running very well. However, from time to time a job will run larger than the tapes in the slots. I had this happen last night after just upgrading to 2.4.0 just the other day.
I changed the tapes and issued a manual mount. This caused:

2008-06-27 06:37:35mt-back4.storage JobId 7775: Please mount Volume "A00009" or label a new one for:
    Job:          Advisen_NAS_Weekly_Tape.2008-06-26_22.00.25
    Storage:      "Ultrium-TD3" (/dev/rmt/0cbn)
    Pool:         Advisen_Tapes
    Media type:   LTO-3
2008-06-27 12:45:22mt-back4.storage JobId 7775: 3301 Issuing autochanger "loaded? drive 0" command.
2008-06-27 12:45:24mt-back4.storage JobId 7775: 3302 Autochanger "loaded? drive 0", result: nothing loaded.
2008-06-27 12:45:24mt-back4.storage JobId 7775: 3301 Issuing autochanger "loaded? drive 0" command.
2008-06-27 12:45:26mt-back4.storage JobId 7775: 3302 Autochanger "loaded? drive 0", result: nothing loaded.
2008-06-27 12:45:26mt-back4.storage JobId 7775: Error: Could not open device "Ultrium-TD3" (/dev/rmt/0cbn): ERR=dev.c:
432 Unable to open device "Ultrium-TD3" (/dev/rmt/0cbn): ERR=I/O error

I was wondering if the cause of this was because I issued a mount after updating slots and then the job tried to issue a mount at the same time, or if this is related to the buggy manual tape code now in 2.4.0?

Thanks,
Shon

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php

_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users