Your in this state after the SD restarts and before it runs a job on the
tape.
                        -Jason

On Tue, 2008-06-24 at 12:01 -0400, John Drescher wrote:
> > Are you sure? From the output of 'status sd' below one can see that tape
> > 'TAG-2' is in use but the storage daemon still reports a poolname 
> > '*unknown*'.
> >
> I have seen this dozens of times in the 4+ years I have used bacula.
> 
> John
> 
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://sourceforge.net/services/buy/index.php
> _______________________________________________
> Bacula-users mailing list
> Bacula-users AT lists.sourceforge DOT net
> https://lists.sourceforge.net/lists/listinfo/bacula-users
-- 
----------------------------------------------------------------------------
Jason A. Kates (jason AT kates DOT org) 
Fax:    208-975-1514
Phone:  212-400-1670 x2
============================================================================



-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users