It is now sg0, I believe.

brian

James Bowes wrote:
> Hi.
>
> I have a bit of a problem. I was doing some timing adjustments in the
> mtx-changer script as I had to it to 100 seconds in a couple of spots.
> Unfortunately, the btape autochanger test kind of hung and I could not
> remove the st module. So I rebooted. Now, I see the changer is attached
> according to dmesg but when I view the scsi devices using lsscsi I can
> see the device but it is not showing as /dev/sg1 which is what it
> previously.
>
> In fact it only shows as a scsi device:
>
> [2:0:1:0]    mediumx ADIC     FastStor DLT     0115  -       
> [2:0:3:0]    tape    QUANTUM  DLT8000          010F  /dev/st0
>
> Any ideas on this one. A hard start on the server? If that happens at
> this point would it most likely happen again?
>
> Thanks in advance.
>
> --james
>
>
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://sourceforge.net/services/buy/index.php
> _______________________________________________
> Bacula-users mailing list
> Bacula-users AT lists.sourceforge DOT net
> https://lists.sourceforge.net/lists/listinfo/bacula-users
>   


-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users