On Fri, May 7, 2010 at 7:19 PM, Luis Paulo <luis.barbas AT gmail DOT com> wrote:
>
> The OP said that he is using tar and $Conf{RsyncArgs} directive...
>

I made a bit of a mess

Steve is using tar, TarShareName is / and is using BackupFilesExclude
on the GUI. Or trying to :)
Not using $Conf{RsyncArgs} directive, as I said. That was Allen

Sorry, Steve
As Allen point out for rsync, you may look at your XferLOG to see the
tar command produced and check the syntax against the tar command
syntax
see http://www.gnu.org/software/tar/manual/tar.html#SEC108

Sorry again about the mess
Luis

------------------------------------------------------------------------------

_______________________________________________
BackupPC-users mailing list
BackupPC-users AT lists.sourceforge DOT net
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/