I'm running amanda 2.6.1 on Solaris 10/x86 and having a problem with
my test of a file restore.

tapedev is /dev/rmt/0hn, its an LTO4, should probably just use /dev/rmt/0n.
Tape is imbedded in an SL24 jukebox, the the problem doesn't seem related
to the robot.

Interestingly, same version was able to run a restore on DLT drive
on solaris 10/Sparc, so I'm thinking me rather than architecture 
(that is solaris sparc v x86, not Amanda architecture), but I don't
know for sure.

Target file system is ZFS produced with snapshots, but again, parallel
config with the Sparc system.

# amrestore /dev/rmt/0hn 
Restoring from tape Curie01 starting with file 1.
amrestore: 1: restoring FILE: date 20090223143428 host curie disk /thump lev 1 
comp .gz program APPLICATION
Could not seek device /dev/rmt/0hn to file 2: Error reading Amanda header.


---
   Brian R Cuttler                 brian.cuttler AT wadsworth DOT org
   Computer Systems Support        (v) 518 486-1697
   Wadsworth Center                (f) 518 473-6384
   NYS Department of Health        Help Desk 518 473-0773



IMPORTANT NOTICE: This e-mail and any attachments may contain
confidential or sensitive information which is, or may be, legally
privileged or otherwise protected by law from further disclosure.  It
is intended only for the addressee.  If you received this in error or
from someone who was not authorized to send it to you, please do not
distribute, copy or use it or any attachments.  Please notify the
sender immediately by reply e-mail and delete this from your
system. Thank you for your cooperation.