Re: Logs and reporting
2008-09-29 12:48:05
Hi All,
I set amanda user to receive the mail.
And this is the mail report
Date: Mon, 29 Sep 2008 17:28:29 +0100
From: Amanda Backup System <amanda AT backupserver.bluebarracuda DOT com>
To: amanda AT backupserver.bluebarracuda DOT com
Subject: Bluebarracuda - Daily Tape AMANDA MAIL REPORT FOR September
29, 2008
Hostname: backupserver
Org : Bluebarracuda - Daily Tape
Config : fullback
Date : September 29, 2008
These dumps were to tape FULLBACK-01.
The next tape Amanda expects to use is: a new tape.
STATISTICS:
Total Full Incr.
-------- -------- --------
Estimate Time (hrs:min) 0:00
Run Time (hrs:min) 0:00
Dump Time (hrs:min) 0:00 0:00 0:00
Output Size (meg) 0.0 0.0 0.0
Original Size (meg) 0.0 0.0 0.0
Avg Compressed Size (%) -- -- --
Filesystems Dumped 1 1 0
Avg Dump Rate (k/s) 1000.0 1000.0 --
Tape Time (hrs:min) 0:00 0:00 0:00
Tape Size (meg) 0.0 0.0 0.0
Tape Used (%) 0.0 0.0 0.0
Filesystems Taped 1 1 0
Chunks Taped 0 0 0
Avg Tp Write Rate (k/s) 12.4 12.4 --
USAGE BY TAPE:
Label Time Size % Nb Nc
FULLBACK-01 0:00 32k 0.0 1 0
NOTES:
planner: Last full dump of localhost:/cache on tape overwritten in 1
run.
driver: WARNING: This is not the first amdump run today. Enable the
usetimestamps option in the configuration file if you want to run
amdump more than
once per calendar day.
taper: tape FULLBACK-01 kb 64 fm 1 [OK]
big estimate: localhost /cache 0
est: 64k out 32k
But the next time i run it i will say
*** A TAPE ERROR OCCURRED: [No writable valid tape found].
Some dumps may have been left in the holding disk.
Run amflush to flush them to tape.
The next tape Amanda expects to use is: a new tape.
Is there any possibility to make it use the same tape over and over
again for this backup.
amanda@backupserver:~$ more /etc/amanda/fullback/tapelist
20080929 FULLBACK-01 reuse
Kind Regards,
Prashant
Jean-Louis Martineau wrote:
Prashant
Ramhit wrote:
Hi All,
Thanks for your help.
Attached is the amdump.1
Do you think its because it is not using the tape FULLBACK-01.
How can I make it to reuse fullback-01 again.
Do the following two command:
amrmtape fullbackfullback-01
amlabel -f fullback fullback-01
Your 'mailto' is set to 'root', did it receive the email report?
Jean-Louis
|
|
|
|