Re: Amanda failing on sendsize
2007-10-16 03:28:21
Hi,
even without debug symbols, you should be able to get a backtrace from
gdb. Do you mind sending that on?
My bad, here it is.
#0 0x2808f46c in debug_stralloc () from /usr/local/lib/libamanda-2.5.1p3.so
#1 0x280a3f08 in append_sl () from /usr/local/lib/libamanda-2.5.1p3.so
#2 0x0804a7d4 in ?? ()
#3 0x00000000 in ?? ()
#4 0x00000000 in ?? ()
#5 0x00000048 in ?? ()
#6 0x0804ab04 in ?? ()
#7 0x280715d8 in ?? () from /libexec/ld-elf.so.1
#8 0x00000001 in ?? ()
#9 0x28059a1c in _rtld_free_tls () from /libexec/ld-elf.so.1
#10 0x08049b0d in ?? ()
#11 0x00000001 in ?? ()
#12 0xbfbfe984 in ?? ()
#13 0xbfbfe98c in ?? ()
#14 0x08049b02 in ?? ()
#15 0x0804f3a8 in ?? ()
#16 0x00000000 in ?? ()
#17 0x00000000 in ?? ()
#18 0x280559f6 in .rtld_start () from /libexec/ld-elf.so.1
#19 0xbfbfe980 in ?? ()
#20 0xbfbfe970 in ?? ()
#21 0xbfbfe974 in ?? ()
#22 0x00000000 in ?? ()
etc.
Note that there have been a *lot* of bugfixes since 2.5.1-p3 -- so
many I don't even recall if something like this was among them. That
said, the backtrace should help us find the culprit.
2.5.1-p3 is the last version available in FreeBSD ports, that is why,
would be faster/easier to install/maintain (if only it worked).
TIA,
Olivier
On 10/15/07, Olivier Nicole <on AT cs.ait.ac DOT th> wrote:
Hi,
Now that I can manually run sendsize, I do get the core dump.
Program received signal SIGSEGV, Segmentation fault.
0x2808f46c in debug_stralloc () from /usr/local/lib/libamanda-2.5.1p3.so
How to recompile amanda with debuging symbols? I see nothing of the
like in the configure script.
Best regards,
Olivier
--
Storage Software Engineer
http://www.zmanda.com
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
|
|
|