Hi I don't have no tpchanger specified in my ~amanda.conf

As
below                                                                           
                                               
# Specify tape device and/or tape changer.  If you don't have a tape
# changer, and you don't want to use more than one tape per run of
# amdump, just comment out the definition of tpchanger.

I am only using one tape per run that does a full backup onto tape.
Thus is there a way to check my tapes I did orderly label them but need
to verify which tape is DailySet4.

Cheers

        
        On Mon, 2005-06-27 at 10:51 -0500, Vicki Stanfield wrote:
> Chuck Amadi Systems Administrator wrote:
> 
> >Hi all
> >
> >I have running amanda for a week but Fridays tape DailySet4 didn't get
> >backed up because The DailySet4 tape is in the drive but my amanda
> >doesn't think So.
> >
> >What is the best way to check what amanda tape it is as I assume when
> >labelling I may of made a mistake.
> >
> >Is there a amanda program that will check what tape I have in the drive.
> >
> >*** A TAPE ERROR OCCURRED: [not an amanda tape].
> >Some dumps may have been left in the holding disk.
> >Run amflush to flush them to tape.
> >The next tape Amanda expects to use is: DailySet104.
> >
> >Here is the message when I run amverify
> >Defects file is /tmp/amanda/amverify.20028/defects
> >amverify DailySet1
> >Mon Jun 27 15:41:39 BST 2005
> > 
> >Using device /dev/nst0
> >Waiting for device to go ready...
> >Rewinding...
> >Processing label...
> >** No amanda tape in slot
> >
> >So whats the best step to correct this.
> >
> >Cheers
> >
> >  
> >
> I would try amtape [config] show.
> 
> Vicki
> 
-- 
Unix/ Linux Systems Administrator
Chuck Amadi
The Surgical Material Testing Laboratory (SMTL), 
Princess of Wales Hospital 
Coity Road 
Bridgend, 
United Kingdom, CF31 1RQ.
Email chuck.smtl.co.uk
Tel: +44 1656 752820 
Fax: +44 1656 752830