Hi,

so now amrecover works as far as switching the tape is concerned, but
i am still unable to recover files :(.  here's the output:

amrecover> extract
Extracting files using tape drive /dev/nst0 on host db1.
The following tapes are needed: DailySet1017
Restoring files into directory /tmp
Continue [?/Y/n]? y
Extracting files using tape drive /dev/nst0 on host db1.
Load tape DailySet1017 now
Continue [?/Y/n/s/t]? y
EOF, check amidxtaped.<timestamp>.debug file on db1.
amrecover: short block 0 bytes
UNKNOWN file
amrecover: Can't read file header
extract_list - child returned non-zero status: 1
Continue [?/Y/n/r]? y

ok, so i'm checking the debug files that it told me to look at, but i
don't see any errors.  Here's the last few lines of the log:

amindexd: time 29.050: < 200  Opaque list of /usr/bin
amindexd: time 38.900: > TAPE
amindexd: time 38.900: < 200 /dev/nst0

that last thing is the 'ls' command i performed, and then there is no
errors or anything (there should be...that's where i did the 'extract'
command).  any tips?

thanks,
Cameron Matheson