Hello,

my storage with amanda this night failed because there was a time-problem
with two concurrent jobs. The dumps are there where they should be (in the
dump-directory). Now I will run amflush, but it doesn't seem to work. The
Process has maximum CPU-Usage, but there is no writing on tape. 

I have no idea where I can begin to search. 

The logfiles don't say anything for errors. amstatus says, that the dumper
will work (see output below), but the process runs about 1 hour. Normally
the writing to tape goes only 13 minutes, so he should hav been finished
now.

-bash-2.05b$ amstatus levap03-do
Using /var/log/amanda/levap03-do/amflush


SUMMARY          part     real estimated
                          size      size
partition       :   0
estimated       :   0                  0k
flush           :   0        0k
failed          :   0                  0k           (  0.00%)
wait for dumping:   0                  0k           (  0.00%)
dumping to tape :   0                  0k           (  0.00%)
dumping         :   0        0k        0k (  0.00%) (  0.00%)
dumped          :   0        0k        0k (  0.00%) (  0.00%)
wait for writing:   0        0k        0k (  0.00%) (  0.00%)
wait to flush   :   0        0k        0k (100.00%) (  0.00%)
writing to tape :   0        0k        0k (  0.00%) (  0.00%)
failed to tape  :   0        0k        0k (  0.00%) (  0.00%)
taped           :   0        0k        0k (  0.00%) (  0.00%)
all dumpers active
taper idle

Or is there a misunderstanding in my point of view of working amflush?

Best regards

Bernd