On Friday, 31.10.2003 at 17:07 -0500, Eric Siegerman wrote:
> > Is there anyway I can change tape label names after I'm well into
> > amanda dumpcycle? I currently have TLS-Set-1-01.. Set-1-02..
> > Set-2-01 and so on. I want to get rid of this set concept from the
> > label.
>
> This is untested; treat it with caution...
>
> 1. To begin the process, change the "labelstr" regexp in
> amanda.conf so that both the old and new label styles are
> recognized.
>
> 2. For the next tapecycle's worth of dumps, you'll have a mix of
> old- and new-style labels. Each day that a tape with an
> old-style label comes up to be reused:
> a. Do "amrmtape <config> <old-label>"
>
> b. Relabel the tape with a new-style label. Amanda will
> consider it to be a "new tape", but that's ok.
>
> 3. After all of the old-style tapes have been relabelled, change
> "labelstr" again, to only accept the new style of labels
>
>
> WARNINGS:
> - DO NOT do (2) all at once for all of the tapes; you'll
> clobber your backups. Make sure you do those steps, for each
> tape, just before Amanda would have overwritten that tape
> anyway.
>
> - If you're still on your first tapecycle, i.e. you're still
> adding new tapes one at a time, you'll have to finish adding
> in your new tapes before you can even begin step (2).
>
> - During this process, you're circumventing all (or most) of
> Amanda's protections against clobbering the wrong tape. So
> be careful!
I'm interested in doing this too, for various reasons. Anyone actually
tried something like this?
Dave.
--
Dave Ewart
Dave.Ewart AT cancer.org DOT uk
Computing Manager, Epidemiology Unit, Oxford
Cancer Research UK
PGP: CC70 1883 BD92 E665 B840 118B 6E94 2CFD 694D E370
|