On Tue, Sep 16, 2003 at 10:23:54AM +1000, Barry Haycock wrote:
> I have inherited an Amanda backup system at the place I work at.
> As this system is a remote access only I had a staff member insert new
> tapes in to the server which is a Solaris 8 using version 2.4.4 writing
> to a sun L20 using dlt tapes 20/40. This system was working after I took
> it over but was not being maintained. I have on the system 2 configs
> daily and monthly backup. After the new tapes went in (I haven't labeled
> them yet) which are to be used under the monthly backup config in order
> to find what slot Amanda thought that they were in I ran a "amtape
> monthly show" since that time when ever any Amanda command is run (not
> just amtape) I get the following errors written to tape0-status at a
> great rate of knots and if left unchecked will fill up the file system
> can anyone point me in the right direction of what is causing the error
> messages and how to resolve them.

Labeling the tapes would be a good start.

How can amtape "show" you what tapes are in
which slots if they have no "names" aka "labels"

-- 
Jon H. LaBadie                  jon AT jgcomp DOT com
 JG Computing
 4455 Province Line Road        (609) 252-0159
 Princeton, NJ  08540-4322      (609) 683-7220 (fax)