On Wed, Jul 09, 2003 at 03:31:13PM -0400, Jon LaBadie wrote:
> On Wed, Jul 09, 2003 at 11:59:23AM -0700, Jay Lessert wrote:
> > You put appropriate entries in /kernel/drv/sgen.conf (it is commented empty
> > by default, so you *have* no devices for it yet), do an 'add_drv sgen' and
> > you should get device entries in /dev/scsi/changer.
> > 
> > The sgen.conf device-type for library robots is "changer".
> 
> Mine showed up in /dev/scsi/sequential rather than changer.

That might be, and I'm sure it works, but "sequential" is sgen-ese for
"tape drive".  I guess your sgen.conf device-type-config-list has
"sequential" instead of or in addition to "changer"?

Even then, it's sort of strange if the robot is returning "sequential"
(0x01) for an inquiry type ID, instead of "changer" (0x08), but...

Anyway, "changer" is sgen-ese for "media library robot".

> You might also edit st.conf to examine other lun's besides 0 (only 0
> is scanned in the default file).

Yup, in any case, you can't do diddly if you don't know the target and
LUN setting for each device on the bus.

-- 
Jay Lessert                               jay_lessert AT accelerant DOT net
Accelerant Networks Inc.                       (voice)1.503.439.3461
Beaverton OR, USA                                (fax)1.503.466.9472