Hello folks

I've only got one tape drive with no robot, so if I have more than
one tape, I change it manually. Thus, I've set up a "manual changer"
configuration; part of that is setting "runtapes 2". So far, so
good.

Now if I run amverify, it verifies once (ok), then rewinds and
*re-verifies the same tape*. According to amverify man page, this is
because I've set runtapes to 2. I would like to set runtapes to 2 so
I can manually change tapes, but not have amverify check the same
tape twice. Is this possible?

-- 
Kurt Yoder
Sport & Health network administrator