Opps, my mistake! Maybe I didn't clarify. AMANDA was running out of tape
at the end of a few runs. I think I will let it run *as is* and see if
it happens again. If so, I'll just run amflush and see if it fits on the
next tape.

Thanks ... Mike

>>> Joshua Baker-LePain <jlb17 AT duke DOT edu> 01/27/03 02:42pm >>>
On Mon, 27 Jan 2003 at 1:53pm, Michael Kopach wrote

> I have the odd tape that fills up from AMANDA. Since I have a
limited
> number of tapes on hand, how does one safely clean out the contents
of
> that tape and reuse it under AMANDA? 

Err, I'm not quite sure what any of this means.  By default, amanda
cycles 
through all the tapes in your tapecycle, writing over the contents on
each 
use.

-- 
Joshua Baker-LePain
Department of Biomedical Engineering
Duke University