As I found in compatibility matrix TSM support L700e with ascs and L700 without
it.
I don’t know what is the difference between L700 and L700e but in general L700
will work and supported only with TSM device driver.
Also I found this question (
https://forums.aws.amazon.com/thread.jspa?messageID=585674 ) with another
problem, but he defined the library in TSM.
Efim
> 4 марта 2016 г., в 15:49, Lee, Gary <glee AT BSU DOT EDU> написал(а):
>
> I do see sg devices, the sg device is loaded into the kernel.
>
> I get an i/o error when trying to define as a libtype=scsi.
>
> If I try to use the stk l700 emulation, I need the accsls software.
> So far, I have found no way to acquire this.
> Don't even see a link to buy anywhere on the oracle sight.
>
>
> -----Original Message-----
> From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf
> Of Efim
> Sent: Friday, March 04, 2016 7:38 AM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: [ADSM-L] more amazon vtl config issues
>
> Hi
> Do you have RHEL storage-server package installed, driver loaded to the
> kernel (lsmod | grep sg) and you can see sg device?
> I correct understood than autoconf doesn’t work? Do you try to run it with -t?
> File op.conf is necessary only for optical library.
> Efim
>
>
>> 25 февр. 2016 г., в 18:09, Lee, Gary <glee AT BSU DOT EDU> написал(а):
>>
>> Tsm v7.1.1,
>> RHEL 6.7 x86_64 platform
>>
>> Trying to get this amazon storage gateway thing going.
>>
>> Got lin_tape installed, and it sees all ten drives in the test library.
>>
>> I think, from reading the administrator's guide, that I must use the tsm
>> devicedrivers for the media changer, at least.
>>
>> Trying to follow the instructions in chapter 5 for configuring with the
>> tsmscsi script.
>>
>> However, have two problems.
>>
>>
>> 1. It says there are no devices in the lb.conf file will paste in
>> below.
>>
>> 2. There is no op.conf.smp to copy and set up.
>>
>> 3. Is this necessary, and if so, could some one send me one?
>> Lb.conf, and the rellavent portion of /proc/scsi/scsi follow:
>>
>> Section of /proc/scsi/scsi
>>
>> Host: scsi12 Channel: 00 Id: 00 Lun: 00
>> Vendor: AWS Model: Gateway-VTL Rev: 0100
>> Type: Medium Changer ANSI SCSI revision: 05
>>
>>
>>
>> Lb.conf
>>
>>
>> HOST[0]=12
>> CHANNEL[0]=0
>> ID[0]=0
>> LUN[0]=0
>>
>>
>> HELP!! Feel like I'm spinning my wheels.
|