Hi
Do you have RHEL storage-server package installed,  driver loaded to the kernel 
(lsmod | grep sg) and you can see sg device?
I correct understood than autoconf doesn’t work? Do you try to run it with -t?
File op.conf is necessary only for optical library.
Efim


> 25 февр. 2016 г., в 18:09, Lee, Gary <glee AT BSU DOT EDU> написал(а):
> 
> Tsm v7.1.1,
> RHEL 6.7 x86_64 platform
> 
> Trying to get this amazon storage gateway thing going.
> 
> Got lin_tape installed, and it sees all ten drives in the test library.
> 
> I think, from reading the administrator's guide, that I must use the tsm 
> devicedrivers for the media changer, at least.
> 
> Trying to follow the instructions in chapter 5 for configuring with the 
> tsmscsi script.
> 
> However, have two problems.
> 
> 
> 1.       It says there are no devices in the lb.conf file will paste in below.
> 
> 2.       There is no op.conf.smp to copy and set up.
> 
> 3.       Is this necessary, and if so, could some one send me one?
> Lb.conf, and the rellavent portion of /proc/scsi/scsi follow:
> 
> Section of /proc/scsi/scsi
> 
> Host: scsi12 Channel: 00 Id: 00 Lun: 00
>  Vendor: AWS      Model: Gateway-VTL      Rev: 0100
>  Type:   Medium Changer                   ANSI  SCSI revision: 05
> 
> 
> 
> Lb.conf
> 
> 
>   HOST[0]=12
>   CHANNEL[0]=0
>   ID[0]=0
>   LUN[0]=0
> 
> 
> HELP!! Feel like I'm spinning my wheels.