[ADSM-L] Drives stays "IN USE" after Library downtime
2014-06-30 15:30:19
Dear All,
after an error at one of our libraries (Quantum i6000, robotics became offline,
we did a reboot instead of driving to the remote location to re-enable it) the
library manager still shows one tape in a drive beeing "IN USE".
but neither the library client who should own this tape / drive at the momten
nor the library itself reports the same:
for the libclient the tape is not mounted
for the library the drive is empty
I tried to do an library audit, this fails immediatly
then i restartet first the library manager instance later the whole physical
server, the libmanager stiil reports the drive "IN USE" with the tape, even if
there no session from the library client :-(
starting a library audit then, took much longer, I canceled this after about
three hours
"dismount vol" does not work either
Any idea what to do?
a little bit off-topic: an IBM 3584 can do an internal inventory run, does
anyone know something similar for the i6k?
Thanks in advance & best regards,
Bjørn
Bjørn Nachtwey <mailto:bjoern.nachtwey AT gwdg DOT de>
Arbeitsgruppe IT-Infrastruktur Tel. +49 551 201-2181
----------------------------------------------------- G W D G ----
Gesellschaft für wissenschaftliche Datenverarbeitung mbH Göttingen
Am Fassberg 11, 37077 Göttingen
E-Mail: gwdg AT gwdg DOT de Tel.: +49 (0)551 201-1510
URL: http://www.gwdg.de Fax: +49 (0)551 201-2150
Geschäftsführer: Prof. Dr. Ramin Yahyapour
Aufsichtsratsvorsitzender: Dipl.-Kfm. Markus Hoppe
Sitz der Gesellschaft: Göttingen
Registergericht: Göttingen Handelsregister-Nr. B 598
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [ADSM-L] Drives stays "IN USE" after Library downtime,
Nachtwey, Bjoern <=
|
|
|