Re: [ADSM-L] TS3310 Tape Library Cleaning Slot
2013-08-19 17:16:40
Hi Geoff
I am not sure for TS3310, but this is the procedure TS3200. What I do is to decrease with
1 number of slots, and put cleaning in the last on 45 ot 47 ( I can not remember) and
after that some where in configuration there is a check box "enable auto
clean". Also if it is not done, set SMTP for notifications...
Normally if cleaning is needed you will receive something like this:
Attention : Drive Cleaning request
Event Code: 0x82 - cleaning request
Drive number: 0x03, 3
This message was generated automatically from
IBM 3573-TL
And do not check-in cleaner in TSM if auto-cleaning for library is enabled...
Hope to help this info ...
Regards
Chavdar
On 8/19/2013 22:25, Geoff Gill wrote:
Hello,
I posted a question which didn't really get any response so I'd like to reword
this to see if anyone has a comment.
This is a TS3310 Tape library. Whoever defined everything initially removed the default
cleaning slot and there is no way to insert a cleaning tape because there are no cleaning
slots defined. There are empty slots available so here is the question. If I go to modify
the logical library and bring the "Configure Storage Slots" number down by 1
slot to free up an empty slot, does anyone know if there is a reboot of the library or
library audit or any issues I need to worry about?
Thank You
Geoff Gill
|
|
|