Robert,

When you are doing virtual volumes like you are doing the virtual volume
on the target server is actually managed as an archive object.
Therefore, I would bet that the archive copygroup for that management
class is pointing at the diskpool.  Also, it is a good practice to put
server nodes for virtual volumes into a separate domain so as not to get
them confused with other nodes policies.  Remember that although it is
using an archive copygroup the only attribute it cares about is the
destination storage pool.  Retention time is irrelevant since it is
managed by the source server.

Good luck and let us know how you made out.

--
Regards,
Mark D. Rodriguez
President MDR Consulting, Inc.

===============================================================================
MDR Consulting
The very best in Technical Training and Consulting.
IBM Advanced Business Partner
SAIR Linux and GNU Authorized Center for Education
IBM Certified Advanced Technical Expert, CATE
AIX Support and Performance Tuning, RS6000 SP, TSM/ADSM and Linux
Red Hat Certified Engineer, RHCE
===============================================================================



Robert Ouzen wrote:

Hi to all

I tried to make a server to server migration here the steps I made:

     On source Server named SERVER1
 1. I define a server SERVER2 (target server)
 2. I define a devclass SERVERCLASS with device type SERVER and servername 
SERVER2
 3. I create a stg SERVER1_POOL with devclass SERVERCLASS

     On target Server named SERVER2
1.  I define a server SERVER1 (source server) with nodename POSTBACK
2.  I create a nodename of type SERVER named POSTBACK
3.  I add this nodename to the STANDARD policy with a copypool destination 
named I2000_SERVER1 (tape storagepool)
4.  Activate the STANDARD policy

I update my primary stg on SERVER1 (source server) named primarypool  with next 
stg SERVER1_POOL

The migration start I see both on the source and target server activity on the 
actlog but I got always this error message:

08/10/2005 20:05:23  ANR0520W Transaction failed for session 23881 for node
                     POSTBACK (Windows) - storage pool DISKPOOL is not
                     defined. (SESSION: 23881)

Why trying to store on DISKPOOL storage ???? I doubled check my STANDARD policy 
and my copygroup is I2000_SERVER1 (I activate several times the STANDARD policy 
and check the active policy to see that I2000_SERVER1 is correct in did !!!!

My TSM version on the source server is 5.2.4.0 Windows      O.S
My TSM version on the target server  is 5.2.4.2 AIX-RS/6000  O.S

Any suggestion ?????

Regards
Robert Ouzen
e-mail: rouzen AT univ.haifa.ac DOT il