OK, a little deeper...
we have 5 groups of stg areas, basically...
Since TSM doesn't give you a good way to "control" (wait=yes is good with
move data, but there's
nothing for, say, migration) the movement from disk to tape we HAVE to use
move data commands...
We have over 100 disk vols.
We simultaneously run move datas.
If one area completes then, it goes onto the ba stg.
ALL move datas and ba stgs have to complete (5 general areas) prior to the
db backup, etc....
A good scheduler, will get this done with ease. Scripting...that would be
complex.