Re: NT dr watson errors
2000-01-05 13:05:51
We are using the same levels as you, have not seen the problem you describe.
I stopped using the base/GA-level of client 3.1.0.7 due to problems fixed in
the latest fixtest, so am not sure of the SP5 timing. Try re-installing the
client (and use the latest fixtest, f2), pay close attention to any prompts
about over-writing DLLs; alternatively, try re-installing SP5 --- either
approach could/should help.
Regarads,
Don
Technical Architect, P.A.C.E.
San Jose, CA
mailto:dfrance AT pacbell DOT net
PACE - http://www.pacepros.com
Bus-Ph: (408) 257-3037
> -----Original Message-----
> From: Walter, Jeannine [mailto:Jeannine_Walter AT PURINA-MILLS DOT COM]
> Sent: Wednesday, January 05, 2000 7:49 AM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: NT dr watson errors
>
>
> Hello all,
> I am currently running ADSM Server v3.1.2.40 on AIX. My NT
> clients are at
> 3.1.0.7. They are NT servers at NT 4 SP 5. Since I upgraded
> the NT servers
> to 3.1.0.7 I have experienced lots of Dr. Watson errors on
> the NT boxes.
> The event log does not report a problem. Dsmsched.log shows
> the back up
> beginning and waiting for a tape mount and that's it.
> Dsmerror.log shows
> nothing. The connection is severed, the client gets a Dr.
> Watson and the
> service shuts down. It must be manually restarted. It will
> then run fine
> for a few days and then same thing. It happens on all of out
> NT boxes both
> Compaq and Dell.
> Anyone else seen this? How can I fix it?
> Thanks for any/all info.
>
> Regards,
> Jeannine Walter
>
> Purina Mills, Inc.
> St. Louis, MO
> 314-768-4181
> Jeannine_Walter AT Purina-Mills DOT com
> <mailto:Jeannine_Walter@Purina-> Mills.com>
>
|
|
|